Con-tech CS2000-QD Manual de usuario descargar pdf (Pagina 5)

- 3 -

General Information

CS2000 Quick Start:

1.  Connect red wire to supply voltage

2.  Connect black wire to supply common

3.  For NPN Output - connect orange wire to black wire

 F

or PNP Output - connect orange wire to red wire

4.  Connect white wire to your controller - refer to page 6 for wiring diagrams

5.  Turn on power

6.  Peel off a label and position the label backing (web) under the sensing area

7.  Depress the push-button until the yellow LED comes on (1 sec.), then release

8.  The yellow LED will begin flashing

9.  Move a label under the sensing area and the green LED will come on

10.  The label sensitivity is now adjusted and the sensor should function correctly

11.  The yellow LED indicates when label backing (web) is detected

12.  The green LED indicates when label over label backing is detected

13.  The red LED indicates when the output is active - NPN sinking or PNP sourcing

1 2 3 4 5 6 7 8 9 10 ... 17 18

Sin comentarios

Con-tech CS2000-QD Manual de usuario Pagina 5